Skip to content
Normal installation
- Make sure the corner of your patio screen door is dry and clean on both sides
- Completely close the door to make sure you stick the Velcro® not completely on the edge
- Stick the male/spiky Velcro® on the back side of the plates and the female/soft Velcro® ON THE DOOR FRAME
- Make sur the round corner of the Smar Slider™ lies above the screen
- Leave the plates in place at least 1 hour to allow the Velcro® to stick well
Installation on an embossed frame
- Use insulation tape for windows
Installation on a frame with a side lamella

- Cut 2 Velcro® in half
- Stick the spiky part on the outer side of the plate’s vertical part
- Stick the soft part on the inner side of the frame’s lamella
Installation on a tighly fitting frame
- Replace the Velcro® by mounting tape (sticky on both sides)
- Know that you will no longer be able to remove and put back the plates as easily
How to use the Smart Slider™
How to temporarily uninstall the Smart Slider™
- Carefully tear off the plates with both hands
How to clean the Smart Slider™
- Carefully tear off the plates with both hands
- Wash the plates with warm soapy water and a piece of cloth
- For tough stains, use a degreaser like WD-40
How to permanently uninstall the Smart Slider™
- Carefully tear off the plates with both hands
- Carefully remove the Velcro® from the frame with both hands
- To remove remaining glue from the frame, use a degreaser like WD-40